Installing The Electronics (Speaker, Control Board, Hall Sensor And Insulation) - KitchenAid KSB5010 Service & Repair Manual

Installing the Electronics (Speaker,
Control Board, Hall Sensor and
Insulation)
53. Mount the speaker box to the inside of the surround
housing with the (2) screws that were removed in
step 20.
Fig. 49) Mount the speaker to the inside of the surround
housing using 2 screws
54. Fasten the electronic control circuit board's ground
screw to the post on the inside of the surround
housing Fig. 50). If the wire was unplugged from the
control circuit board connector when removed, plug
the wire back into the board by sliding the connector
over the spade on the circuit board.
Fig. 50) Fasten the control ground wire to the inside of the
surround housing (International Models only)
55. Plug both the motor and power cord into the
electronic control circuit board making sure that they
snap into place in the sockets located near the
bottom of the board. Put the board with its mounting
bracket in place in the surround housing and secure
with the (2) 8-32 x .540 screws (Fig. 51).
Fig. 51) Secure the electronic control circuit board to the
surround housing with 2 screws
56. Plug the hall sensor wire into the motor housing
making sure that it snaps securely into place (Fig.
52).
Fig. 52) plug the hall sensor into the motor bracket
57. Replace the insulation that was removed in step 15.
Be sure to orient it such that the slot for the wires is
on your left (as you are facing the unit) and that the
wings are tucked in on either side of the motor (Fig.
53). Route the motor wires through the openings in
the insulation (Fig.54).
- 22 -