KitchenAid KSB5010 Service & Repair Manual page 14

25. Remove the (5) 10-24 x .750 screws that hold the
base to the lower housing (Fig. 25). Remove the
base with the screws and set aside.
Fig. 25) Remove the (5) screws that secure the base to the
lower housing
26. Turn the unit so that the back is toward you and
remove the 6-32 x .250 trimband screw and
trimband (Fig. 26).
Fig. 25) Remove the screw that secures the trimband to the
lower housing
27. Remove the (2) remaining 8-32 x .540 screws that
secure the surround housing to the lower housing.
The insulation at the back of the unit may need to be
moved in order to locate the screws (Fig. 26).
Note: One of the screws will have a star washer on it.
Do not lose this washer as it can get lost inside the unit
and can easily be captured by one of the magnets on the
lower coupler drive (Fig. 27).
Fig. 26) Remove the 2 remaining screws securing the
surround to the lower housing
Fig. 27) Do not lose the star washer from the screw (see Note
on step 25)
28. Remove the cord grommet from the surround
housing (Fig. 28).
Fig. 28) Remove the cord grommet from the surround
housing
- 14 -