Table of Contents
Advertisement
Display
The mITX-APL board supports onboard graphics through two independent interfaces
simultaneously: Two DP-Ports and the LVDS-Port.
Graphics Controller
NXP PTN3460I/PTN3460BS
DP to LVDS
Controller
two Display Ports and LVDS
Display Interface
Note: Three (3) Independent Displays Max.
DP/LVDS 4096x2304 @ 60 Hz, 24 bpp (One panel display)
Resolution
Ethernet
Intel GE WGI210IS/WGI211AT
Controller
IEEE 802.3 10BASE-T / 100BASE-TX / 1000BASE-T compliant
Interface
Audio
The on-board Audio circuit implements six Channel High Definition Audio with UAA (Universal
Universal Audio
Audio Architecture), featuring three 24-bit stereo Digital-to-Analog converter (DACs) and two
Architecture (UAA)
24-bit stereo Analog-to-Digital Converter ADC.
Power
All used power rails are generated internal by a highly integrated DC/DC power unit
Onboard Power
Supply
The mITX-APL is operated by a single 12 to 24 V wide Input Voltage (VIN) DC supply from DC
External Power
Jack on rear I/O Singatron 2DC1003-010111 or optionally 12 V DC supply through an internal
Supply
ATX 4-pin header.
Danger of explosion if the lithium battery is incorrectly replaced.
•
•
The two standard outputs in the rear are connected directly to Display Port
connectors.
The alternative output will be converted from Embedded DisplayPort (eDP) to LVDS.
The LVDS conversion is done by NXP PTN3460BS DisplayPort to dual-channel 24-bit
LVDS converter. Configuration for 1x18-, 1x24-, 2x18- and 2x24-bit / pixel can be
selected by resistor option on board. The LVDS interface is provided on a standard
40-pin connector.
Voltage Ripple specification max ±5 % peak to peak 0 to 20 MHz
Rise Time specification 2 to 20ms from input voltage <10% to nominal VCC
Replace only with the same or equivalent type recommended by the manufacturer
Dispose of used batteries according to the manufacturer's instructions
www.kontron.com
Doc. Rev. 1.2
mITX-APL
// 19
Advertisement
Table of Contents
