CODELOCKS CL1200 Programming & Operating Instructions page 2

CODES - THE BASICS
B) SINGLE USE (Locker Mode)
code levels available: The User enters a single use
i) Master Code code which will lock and then
ii) Sub-Master Code open the lock once only and
iii) User Code then be erased.
iv) Technician Code
The lock will now remain open until
the next single use code is entered
with two factory set codes:
into the lock.
Master Code: 11 33 55 77
e.g. a locker in a leisure centre.
User Code: 22 44
This function is used for short
immediately
term, multi occupancy applications.
change the Master Code
and User Code.
Master Codes are 8 digits long.
6 digits long.
at 4 seconds.
FUNCTIONS
Before programming select the
most appropriate function for
the application.
A) REPEATED USE
Important Note: This is the
default function and is already
pre-programmed in new locks.
This is the most common
function and is used where
the same code will be
repeatedly used.
OPERATING INSTRUCTIONS
The CL1200 Cabinet Lock has a 10 button keypad and a button.
The button is only used for programming functions when lock is in
repeated use mode A).
Blue LED = Code accepted
Red LED = Code rejected
Codes
The lock has the following code levels:
A) Master Code
The Master code can:
B) Sub-Master Code
The Sub-Master Code can:
C) User Code
The User Code can:
D) Technician Code
The Technician mode code can:
use mode B).
The same code cannot be programmed into more than one level
Lost Code Procedure
Lost Code Procedure
Note: The procedure requires the door to be open
Blue LED will flash
twice, release the 1 button. Within three seconds press the 1 button
three times. The Blue LED will flash twice and the lock will have reverted to
the factory Master Code 11 33 55 77 and all other stored settings will be
erased.
Penalty time
Battery Power
The Cabinet Lock should provide well in excess of 50,000 openings,
of 4 seconds each, from 2 x AAA 1.5v cells.
Low Battery
When the battery power is low the Red LED will flash three times
before the Blue LED lights accepting the code. Fit new batteries as
soon as this happens.
Code rejected / low battery indication
Code accepted
PROGRAMMING THE LOCK
Battery override
The Cabinet Lock has been designed so an button when in A) repeated use mode (factory default), followed by
either the Master Code, Sub-Master Code or User Code.
external PP3 battery can be placed against
the external contacts beneath the handle
is not required for programming.
so that the lock can be opened to replace
batteries should they fail.
entry if a mistake is made.
The procedure is as follows:
input; otherwise the program will once again clear.
battery against the contact points at the
base of the lock, making firm maintained
contact.
PP3 terminal against the negative contact
on the lock. See image.
allowing the lock to open.
from the door. Refit the lock.