Kemppi MLS 2300 ACDC Service Manual page 9

Setup functions
AC frequency **
AC waveform **
Half cycle AC
AC balance **
Negative ignition current *
Positive ignition current *
Positive ignition sequence time *
Ignition cycle total time *
MIX TIG cycle time **
*Setting is always on
**Adjustable also by the Quick Setup
***Note panel software version
60 Factory setting 60 Hz
E1
50...250 Adjustment range 50...250 Hz
Sqr Square wave
E2
Sin Sinus wave
5 Factory setting 5 A
E3
5...20 Adjustment range 5...20 A
-25 Factory setting -25 %
E4
-50...10 Adjustment range -50...10 %
100 Factory setting 100 %
E5
100...500 Adjustment range 100...500 % (Limited by
the max. of the power source)
50 Factory setting 50 %
E6
30...150 Adjustment range 30...150 % (Limited by
the max. of the power source)
10 Factory setting 10 = 0,01 s
E7
0...20 Adjustment range 0...20 = 0,0...0,02 s
0.20 Factory setting 0,2 s (up to 0A8) / 0,01 s
(since 0A9).
E8
0.01...1,0 Adjustment range 0,01...1,0 s.
0.6 Factory setting
E9
0.1...1,0 Adjustment range 0,1...1,0 s.
9