Removing A Burner Base & Ignitor - KitchenAid KGCV465MSS Technical Education

REMOVING A BURNER BASE & IGNITOR
WARNING
Electrical Shock Hazard
Disconnect power before
servicing.
Replace all parts and panels
before operating.
Failure to do so can result in
death or electrical shock.
Shut off gas supply line valve
before servicing.
Check all gas line connections
and replace all parts and panels
before operating.
Failure to do so can result in
explosion, fire or other injury.
1. Turn off gas supply and disconnect power
to the cooktop.
2. Remove the cooktop from the unit (see
page 4-2 for the procedure).
3. To remove a standard burner base and
ignitor:
a) Use a 1/2" open-end wrench and re-
move the gas line.
b) Disconnect the ignitor wire from the
ignitor terminal.
c) Remove the two hex-head screws from
the burner base bracket and remove
the burner assembly from the unit.
Standard Burner Base
Ignitor
Wire
Fire Hazard
Bracket Screw
(1 of 2)
Gas Line
d) Turn the burner assembly upside down
and remove the screw from the ignitor,
then remove the ignitor from the burner
base.
e) Remove the two burner base hex-head
screws from the bracket and remove
the burner base.
Burner Base Screws
Ignitor Screw
4. To remove the TripleTier
base:
a) Use a 1/2" open-end wrench and re-
move the rear gas line.
b) Remove the three T-20 torx burner
base screws.
4-4

Crown burner
Rear Gas Line
Burner Base
Screw (1 of 3)