KitchenAid KGCV465MSS Technical Education page 11

8. Install the L.P. orifices in the burners (see
the charts for the proper locations).
Parts provided with conversion kit:
L.P. Orifice Package—8285442
Conversion Instructions—8285441
Conversion Label—8285453
L.P. Orifice Package for

TripleTier Crown Burner—8285443
Standard Burners (4)
Rating Color
5,000 B.T.U. Red
12,000 B.T.U. Blue

TripleTier
Rating Color
11,800 B.T.U. Brown
2,200 B.T.U. Orange
9. Replace the burner caps and grates.
10. To set the low flame size for the stan-
dard burners:
a) Remove the control knob from the gas
valve.
b) Turn on the power and gas and set the
flame to the LO setting.
c) Insert a flat-blade screwdriver into the
hollow stem of the gas valve and en-
gage it with the slot in the adjustment
screw. Turn the screw until the flame
size is as small as possible without
going out.
Size Burner
0.70 mm Small
1.10 mm Large
Crown Burner
Size Burner
1.00 mm External
0.42 mm Internal
Standard Burner
Flame LO Adjustment
d) Quickly turn the gas valve from LO to
HI, and then back to LO. The flame
should be on steady and not go out.
11. To set the TripleTier
a) Remove the control knobs from the five
gas valves.
b) Remove the control panel from the front
panel (see page 4-6).
c) Pull the rubber shield off the gas valve
stem.
d) Turn on the power and gas and set the
inner and outer burner flames to the LO
setting.
e) One at a time, insert a flat-blade screw-
driver into the slot in the external and
internal adjustment screws. Turn each
of the screws until the flame sizes are
as small as possible without going out.

TripleTier Burner
External Flame
LO Adjustment
f) Quickly turn the gas valve from LO to
HI, and then back to LO. Both flames
should be on steady and not go out.
2-3

Crown Burner:

TripleTier Burner
Internal Flame LO
Adjustment