mabe Kraken Service Manual page 68

Fault Name Description
Code
(Hex)
13 Redun In spin mode, the lid
dant switch feedback has
Lid voltage (lid closed), for
Unlock more than 5 seconds
ed the motor speed
feedback assumes the
basket is spinning > 4-
5 RPM when the lid
lock feedback has no
voltage (Lid
Unlocked). Lid Switch
Feedback has no
Voltage when the
BRPM is > 4-5 RPM.
14 Lid Signal received by
Lock control is indicating the
Failure lock will not lock or
unlock when
requested or the lid
switch is indicating
open when the signal
received indicated
locked.
15 Water 1. Thermistor
Temp disconnected/not
Sensor present.
invalid 2. Failed Thermistor
Ingeniería de Servicio
Fault Codes
Repair Action
 Check lid switch continuity at J513 on the
control.
 Check continuity of lid lock position. Opened
or Closed.
 Check for proper operation of lid lock, 120
VAC while activating.
 Check lid lock wiring harness from the
control to lock assembly.
 If lid lock assembly and harness are OK,
replace control board.
 Verify that the lid lock is not blocked by any
external debris.
 Check lid switch continuity at J513 on the
control.
 Check continuity of lid lock position. Opened
or Closed.
 Check for proper operation of lid lock. 120
VAC while activating.
 Check lid lock wiring harness from the
control to lock assembly.
 If lid lock assembly and harness are OK,
update the software.
 Check thermistor resistance from connector
J701 on the control board. Validate the
resistance matches the table in mini-manual.
 Check wiring harness and connectors.
 Replace thermistor
- 68 -