mabe Kraken Service Manual page 29

Ingeniería de Servicio
The harness grommet for the lid lock
does not need to be removed unless
replacing the top cover.
If replacing the top cover, squeeze
the two clips on the grommet and
push it through the opening. Transfer
to the new cover
Remove lid assembly and the control panel
assembly.
Remove two ¼ in. hex head screws (one on
each side) at the rear corners of the top
cover.
Slide the harness grommet out toward the
rear of the washer.
Disengage the power cord from the top
cover by lifting up on the front of the cord
grommet, slide forward and up off of the top
cover.
Raise the rear of the top cover up, then pull
forward slightly to disengage from the front
clips that secures the front of the top cover
to the cabinet.
- 29 -