System Bios And Setup; Entering Setup - Mitsubishi Electric Apricot FT1200 Owner's Handbook Manual

7

Entering Setup

SYSTEM BIOS AND SETUP

The basic input-output system (BIOS) is permanently encoded in
an area of read-only memory (ROM). It can be modified or
upgraded if necessary, but this is recommended to be undertaken by
an authorised engineer. It requires specialist software.
BIOS Setup is a utility within the computer BIOS. Its main
purpose is to allow you to view and alter the computer hardware
configuration. It is also used to configure various security and
power-saving options.
The current configuration is kept in a special area of memory, called
CMOS memory, and maintained by a small battery, so the
configuration is preserved while the computer is switched off, along
with other settings like the date and time.
Caution Caution
The BIOS has been set in our factory for the optimum system
performance and operation. It is not advisable to alter any settings
under normal use.
Not long after turning on your computer, the Mitsubishi symbol
appears at the top right hand side of the screen:
While this symbol is displayed and the memory is counting, you can
press the F1 key to enter the BIOS Setup utility. You can only enter
the setup utility at this time and by this method. It will take a few
seconds for the utility to load.
Hint Hint
A page is provided at the end of this chapter to make a note of your
current BIOS settings.
FT1200 OWNER'S HANDBOOK 7/1