Configuring Port - HIKVISION iDS-TCM203-A User Manual

● The Multicast sends a stream to the multicast group address and allows
multiple clients to acquire the stream at the same time by requesting a copy
from the multicast group address. Before utilizing this function, you have to
enable the Multicast function of your router.
Number plate data can be transmitted through ANPR protocol. Before using
●
this function, you have to configure ANPR IP address and ANPR port to
connect the host.

DNS Server Configuration
DNS (Domain Name System) is a network system used to translate names into IP
address.
3. Click Save to save the settings.

8.5 Configuring Port

Purpose:
Configure the HTTP port, RTSP port, SDK port information on this page.
Steps:
1. Go to Configuration > Device Configuration > System Configuration > Port.
2. Configure the following parameters.
 HTTP Port: The default port number is 80, and it can be changed to any port No.
ranges from 1 to 65536 which is not occupied, except 21 (FTP port) and 23
(Telnet port).
 RTSP Port: The default port number is 554 and it can be changed to any port No.
ranges from 1 to 65536 which is not occupied, except 21 (FTP port) and 23
(Telnet port).
 SDK Port: The default server port number is 8000, and it can be changed to any
User Manual of Network Traffic Camera revise
Figure 8-5 Port Configuration
28