Chapter 2 Network Connection; Wiring Over The Lan - HIKVISION iDS-TCM203-A User Manual

Chapter 2 Network Connection

Note:
 You shall acknowledge that the use of the product with Internet access might be
under network security risks. For avoidance of any network attacks and
information leakage, please strengthen your own protection. If the product does
not work properly, please contact with your dealer or the nearest service center.
 To ensure the network security of the camera, we recommend you to have the
camera assessed and maintained termly. You can contact us if you need such
service.
Purpose:
To view and configure the camera via a LAN, you need to connect the camera in the
same subnet with your computer, and install the SADP to search and change the IP
address of the camera.
Note: For the detailed introduction of SADP, please refer to Appendix.

2.1 Wiring over the LAN

The following figures show the two ways of cable connection of a camera and a
computer:
Purpose:
 To test the camera, you can directly connect the camera to the computer with a
network cable as shown in Figure 2-1.
 Refer to the Figure 2-2 to set camera over the LAN via a switch or a router.
User Manual of Network Traffic Camera
Network Cable
Traffic Camera
Figure 2-1 Connecting Directly
Computer
8