serial port. Device parameters can be configured by using software such as
HyperTerminal. The serial port parameters must be the same as the serial port
parameters of the camera.
•
Transparent Channel: Connect a serial device directly to the camera. The
serial device will be controlled remotely by the computer through the
network.
Steps:
1. Go to Configuration > Device Configuration > System Configuration > Serial
Ports.
2. Configure the RS-485 and RS-232 parameters.
3. Click Save to save the settings.
8.4 Configuring TCP/IP Settings
Purpose:
TCP/IP settings must be properly configured before you operate the camera over
network.
User Manual of Network Traffic Camera revise
Figure 8-3 Serial Ports Settings
26