HIKVISION iDS-TCM203-A User Manual page 33

Steps:
1. Select Synchronization Mode as NTP Synchronization.
2. Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions with NTP
server.
Note: If the camera is connected to a public network, you should use a NTP
server that has a time synchronization function, such as the server at the National
Time Center (IP Address: 210.72.145.44). If the camera is set in a customized
network, NTP software can be used to establish a NTP server for time
synchronization.
4. Click Save to save the settings.
 Configuring DST (Daylight Saving Time)
Steps:
1. Go to Configuration > Device Configuration > System Configuration > DST.
2. Check Enable DST.
3. Set Start Time, End Time, and DST Bias.
4. Click Save to save the settings.
User Manual of Network Traffic Camera revise
Figure 8-9 NTP Synchronization
32