Table of Contents
Advertisement
Wireless Adapter (WA100-PM)
Switch Adapter Mode
Light output ID
Light + Switch (driver and switch are the same type): the connected driver matches the operational capability
of the switch. For example:
•
If the Switch type is "Dimming," a dimming switch and 0-10V dimmable driver are both connected to the
See Figure 10.
WA100-PM.
•
If the Switch type is "On/Off (no dimming)" an On/Off switch is connected to the WA100-PM digital input
and On/Off driver(s) are connected to the WA100-PM's line voltage Switched Load connection and/or an
external relay connected to the WA100-PM's low voltage digital output .
•
If the Switch type is "Bi-Level," a bi-level driver and bi-level switch connect to the WA100-PM.
No Light (switch only): provides wireless adaptation for the selected switch type only. No light is connected to
the WA100-PM.
Occupancy Sensor Time Delays
Occupancy sensor time delays must be set for minimum.
When the ControlScope lighting control network is commissioned, time delays are set in the Daintree ControlScope
Manager (CSM) system. These CSM "Off delays" start counting down after the sensor's internal time delay expires.
Therefore, set occupancy sensors for the minimum time delay during the WA100-PM installation.
Wiring
Line voltage wiring connects to the electrical supply circuit and to the driver(s). The Black (Hot) flying lead and the Red
(Switched Load) flying lead are 14AWG. The White (Neutral) flying lead is 18AWG.
Low voltage 22AWG flying leads provide for connections to supply low voltage power and carry control signals to and
from low voltage devices such as switches, dimmers, photocells, isolated relays and 0-10V analog dimming driver
controls. Do not connect any single low voltage device to more than one WA100-PM.
While the WA100-PM is in Installation Test mode the low voltage devices connected to the WA100-PM directly control
the lights wired to the same WA100-PM. After you exit Installation Test mode, the lights turn On and are NOT controlled
by the devices connected to the WA100-PM.
After joining the wireless network, the control signals from the low voltage devices pass through the WA100-PM and
are sent wirelessly to the ControlScope network. Depending on the zone and device configuration in the CSM, wireless
signals from the WAC to the WA100-PM determine the operation of the light(s).
Design Caution
Wireless adapters must always be provided with uninterrupted power. Do not install
a wireless adapter such as the WA100-PM to control an electrical circuit that provides
power to other wireless devices or adapters. If power to wireless adapters or devices
is shut off, control and communication with them is disabled.
continued
4
Hide quick links:
Advertisement
Table of Contents
