Table of Contents
Advertisement
Wireless Adapter (WA100-PM)
DIP Switch Mode descriptions
Light Adapter Mode
Control Type
On/Off + 0-10V dimming: provides On/Off control using its line voltage Switched Load connection to the driver(s).
It also provides 0-10V dimming control to the driver(s).
On/Off (no dimming): provides On/Off control using its line voltage Switched Load connection, and its low voltage
digital output to an external relay. Note, both outputs are switched at the same time in this driver control mode.
Alternate: provides On/Off switching for one driver load using its line
voltage Switched Load connection, and its low voltage digital
output to an external relay to switch a second driver load. This allows
lighting level control for no load (0%), one or the other of the two loads,
and both loads (100%). See Figure 13.
Bi-Level: provides On/Off switching for one driver with two loads using its
line voltage Switched Load connection and low voltage digital output
an external relay to switch the second load. This allows lighting level
to control for no load (0%), partial load (according to driver capability)
or full load (100%). See Figure 12.
No Driver (sensors only): provides wireless adaptation to connected occupancy sensor and/or photosensor only.
No driver control.
Sensor
To provide wireless adaptation for sensors, set DIP switches 1, 5 & 6 according to the type(s) of sensors
connected to the WA100-PM.
Range Extender
The WA100-PM joins the ZigBee network and acts only as a wireless repeater to improve the wireless range
and/ or reliability. No lights or devices are connected to the WA100-PM.
Switch Adapter Mode
Switch Type
Dimming: operating the connected switch generates dimming and On/Off signals.
On/Off (no dimming): operating the connected switch generates On/Off signals.
Alternate: operating the connected switch will switch separate drivers, providing no load (0%), partial
load (one or the other of the two loads, according to the driver loading) or full load (100%).
Bi-Level: operating the connected switch will switch loads independently in a bi-level driver (or 2 drivers),
providing no load (0%), partial load (according to the driver capability or driver loading) or full load (100%).
Alternate Switching States
Intensity Level
WA100 Switched Aux Relay
Off (0%)
Off
Low (1-49%)
On
Medium (50-99%)
Off
Maximum (100%)
On
Bi-Level Switching States
Intensity Level
WA100 Switched Aux Relay
Off (0%)
Off
Medium (1-99%)
On
Maximum (100%)
On
3
Off
Off
On
On
Off
Off
On
Hide quick links:
Advertisement
Table of Contents
