Dimming Light Fixture(S), Photosensor Configuration - Current WA100-PM Installation Instructions Manual

Wireless Adapter (WA100-PM)
Fig. 8: Dimming Light Fixture(s), Photosensor configuration:
This configuration allows the WA100-PM to provide automatic 0-10V dimming control and to switch light fixtures On/Off.
Line Voltage
Wires
RED Switched Load
120-277VAC
Hot
Dimming Ballast
Neutral
or LED Driver
(0-10VDC)
Hot
Dimming Ballast
or LED Driver
Neutral
(0-10VDC)
DT113 (Rev. 12.8.17)
WHITE Neutral
BLACK Hot 120-277VAC
Wireless Adapter with Power Monitoring
Model: WA100-PM
Input: 120-277VAC, 50/60 Hz
Load: 15A@120-277VAC Ballast or Incandescent, 1hp@120-230VAC
Output: +24VDC; 75mA
Ambient Temperature -4° to 149°F (-20° to 65°C)
FOR INDOOR USE ONLY UL 2043 Plenum Rated
Patent: www.daintree.net/company/patents
00228103007-00000
IEEE Address:
GRAY (-) GRAY Analog Ground
*
VIOLET (+) VIOLET 0-10V Analog Output (dimming control)
*
GRAY (-)
VIOLET (+)
*
0-10V Dimming output
5 mA available
Up to 10 LED drivers or fluorescent ballasts typical; the chance of low voltage errors increases with more.
Driver:
On/Off + 0-10V
dimming
Blue (Digital In 1)
15A
Load
Yellow (Digital In 2)
Relay
Orange (0-10V In)
45mA
Red (24VDC Output)
White
Black (Ground)
Green (Digital Out LSD)
15A+45mA
Violet (0-10V Out)
Gray (Ground)
CONTAINS FCC ID: Z6G-DT357
CONTAINS IC: 10478A-DT357
RoHS
C US
CAN ICES-3 (B)/NMB-3(B)
24V in
24VDC
Photosensor
Common
0-10V output
0-10V Out
DIP Switches
Wired Sensor:
↓ OFF
DIP Switch Positions:
O
Photosensor
N 1 2 3 4 5 6
( #6 ON )
RED 24VDC Power Output
BLACK Digital Ground
ORANGE 0-10V Analog Input
10
ON
Low Voltage
Wires
Cap unused
wires.