Any Switch(Es) + Any Matching Light Type(S); Occupancy Sensor Only; Photosensor Only; Switch Only - Current WA100-PM Installation Instructions Manual

Wireless Adapter (WA100-PM)
Test Suite 4:

Any Switch(es) + Any Matching Light Type(s)

1. Press and immediately release the blue Reset button. The red Error LED flashes once, then pauses and repeats.
2. Check that the connected lights cycle On and Off, or cycle from maximum to minimum brightness then turn
Off per the DIP switch configuration.
3. Press and immediately release the blue Reset button again. The red Error LED flashes four times, then pauses
and repeats.
4. Operate the switch(es) connected to the WA100-PM and observe that the lights turn On, Off, and Dim as expected.
5. Press and immediately release the Reset button to exit testing.
6. Press and hold the blue RESET button on the WA100-PM for 3 seconds to reset the unit . Release the button
when the green Joined
Test Suite 5:

Occupancy Sensor Only

1. Press and immediately release the blue Reset button. The red Error LED flashes twice, then pauses and repeats.
2. Trigger the occupancy sensor. The green Joined LED turns On. When the sensor times out the Joined LED
turns Off.
3. Press and immediately release the Reset button to exit testing.
4. Press and hold the blue RESET button on the WA100-PM for 3 seconds to reset the unit . Release the button
when the green Joined
Test Suite 6:

Photosensor Only

1. Press and immediately release the blue Reset button. The red Error LED flashes three times, then pauses
and repeats.
2. The green Joined LED begins to flash. Increase the amount of light at the photosensor by shining a bright light
at it . The green Joined LED flashes at a faster rate.
3. Press and immediately release the Reset button to exit testing.
4. Press and hold the blue RESET button on the WA100-PM for 3 seconds to reset the unit . Release the button
when the green Joined
Test Suite 7:
Switch Only (On/Off, Dimming, Alternate Switching or Bi-Level)
1. Press and immediately release the blue Reset button. The red Error LED flashes four times, then pauses
and repeats.
2. Operate the switch connected to the WA100-PM. The green Joined LED turns On for the duration of the switch
activation (applies to On, Off, and Dim functions).
3. Press and immediately release the Reset button to exit testing.
4. Press and hold the blue RESET button on the WA100-PM for 3 seconds to reset the unit .
Release the button when the green Joined
LED and the red Error LEDs begin flashing.
LED and the red Error LEDs begin flashing.
LED and the red Error LEDs begin flashing.
LED and the red Error LEDs begin flashing.
24