Fcc Warning Message - Current WA100-PM Installation Instructions Manual

Wireless Adapter (WA100-PM)

FCC warning message

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and radiates radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encourage to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna;
• Increase the separation between the equipment
and receiver;
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected;
• Consult the dealer or an experienced radio/TV
technician for help.
Industry Canada (IC) Warning
Message
Product complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
This device must accept any interference received,
including interference that may cause undesired
operation. CAN ICES-005 B / NMB-005 B
Call 1 888 694 3533
GE is a trademark of the General Electric Company. All other trademarks are the property of their respective owners.
Information provided is subject to change without notice. All values are design or typical values when measured
under laboratory conditions. Current and GE Lighting are businesses of the General Electric Company. © 2017 GE
products.currentbyge.com
Input Voltage 120-277VAC, 50-60Hz
15A driver/incandescent @ 120-277VAC
Switched Output Relay
1hp @ 120-230VAC
(switched to Hot/Active)
Low Voltage Output 24VDC; 75mA maximum
Low Voltage Wiring
Intel ® Atom™ Processor E3805
22AWG, 600V, UL 1015, plenum rated Max.
Memory and Storage
recommended length of up to 100' (30m)
0-10VDC, 5mA max (sink or source), up to
Analog Dimming
10 typical 0.5mA sinking drivers/ballasts*
Analog Input
Photosensor 0-10VDC
Active high. Occupancy sensor,
Digital Inputs (2)
Dim Up/Down (switch mode)
LSD (low side driver) aux relay control,
Digital Output 75mA maximum (including attached
sensors)
2.4 GHz, +8 dBm, Range dependent
Radio Properties
on RF propagation variables such as
metal obstacles
Indoor, dry location
Operating Environment
-4o to 149oF (-20o to 65oC)
Compliance CSA certified, plenum rated, FCC Part 15, CA IC
½" knockout, screw tab, optional mount-
Mounting
ing bracket supplied
9.4" L x 1.7" W x 1.18" H
Dimensions
10.1" L x 1.7" W x 1.18" H with
mounting bracket
* "Driver" references include "ballasts" unless otherwise noted.
27