Adjustments; Platform Slide Clamp Adjustment - Vinten Vector 700H Operator's Manual

Adjustments

After considerable use the platform slide clamp may require adjustment.
To enable the payload to be correctly balanced, the wedge adaptor may require repositioning.
The pan and tilt brakes may require adjustment after considerable use.

Platform slide clamp adjustment

The platform slide clamp should be set so that, in the up or clamped position it prevents the plat-
form slide from being moved, while in the down or released position it allows free adjustment of the
slide. To adjust the clamp, proceed as follows:
On the right-hand side of the platform, carefully remove the self-adhesive label
veal the slotted shaft (17.1).
Pull the slide clamp lever
Slacken the clamp screw (17.3).
Turn the slotted shaft
Tighten the clamp screw (17.3).
Move the lever over its full range and ensure that, in the clamped position, it prevents the
slide from being moved, while in the released position it allows free adjustment of the slide.
Re-adjust if necessary.
Replace the self-adhesive label
(17)
(17.3)
(17) fully upwards.
(17.1) fully clockwise to apply the clamp.
(17.2) in the recess in the platform.
Platform slide clamp adjustment
(17.2) to re-
(17.1)
(17.2)
17