3. From the rear side of the device, install the rear mounting brackets on both sides of the
device.
4. Align the rear mounting brackets to the rack holes. Then secure the rear mounting brackets
using the screws.
5. If installing a single switch only, go to "Connecting to a Power Source".
6. If installing multiple switches, mount them in the rack, one below the other, in any order.
AG9064 Spine Switch
(Figure 3-2: Securing the Front Mounting Bracket)
(Figure 3-3: Installing the Rear Mounting Brackets)
(Figure 3-4: Securing the Rear Mounting Brackets)
12