Chapter 3: Installation; Mounting - Delta AG9064 Installation Manual

3.1

Mounting

This switch can be mounted in a standard 19-inch equipment rack or on a horizontal surface.
Mounting instructions for each type of site follow.
3.1.1 Rack Mounting
Prior rack mounting the switch, pay particular attention to the following factors:
Mechanical Loading: Do not place any equipment on top of a rack-mounted unit.
•
Circuit Overloading: Be sure that the supply circuit to the rack assembly is not overloaded.
•
Grounding: Rack-mounted equipment should be properly grounded. Particular attention
•
should be given to supply connections other than direct connections to the mains.
To rack-mount devices:
1. Install the front mounting bracket to the device using the six M4 screws provided in the rack
mounting kit.
2. Align the front mounting bracket to the rack holes. Then secure the front mounting bracket
using the screws.

Chapter 3: Installation

(Figure 3-1: Installing the Front Mounting Bracket)
NOTE:
Rack screws and clip nuts are not supplied in the rack-mounting kit.
CAUTION:
Due to the switch's weight, it should be installed by at least two people.
MISE EN GARDE:
À cause du poids du commutateur, au moins deux personnes doivent l'installer.
11