Cochlear Baha 5 Quick Manual page 3

Quick guide for Baha® 5 Sound Processor users
Cochlear™ Wireless TV Streamer
Using the Cochlear Wireless TV Streamer
Pairing with your Baha sound processor
A
Make sure the TV Streamer is
plugged into a wall socket with the
green power light on.
Green power light
B
Turn off your sound processor.
C
Press the pairing button on the
TV streamer once to activate its
pairing mode.
Pairing button
Activating streaming
After installation, you can listen to streamed audio from the TV
Streamer by following these simple steps:
First, switch on your TV, sound system or computer and then,
press and hold down the button (long press) on your sound
Support
For full details about the Cochlear Wireless TV Streamer, please
refer to the User Manual.
For full details about the Cochlear Baha sound processor, please
refer to the User Manual part A.
Manufacturer:
Cochlear Bone Anchored Solutions AB Konstruktionsvägen 14, 435 33 Mölnlycke, Sweden
Tel: +46 31 792 44 00 Fax: +46 31 792 46 95
www.cochlear.com
Ardium, Baha, Baha Divino, Baha Intenso, Baha SoftWear, BCDrive, DermaLock, Vistafix and WindShield are either trademarks or registered trademarks of Cochlear Bone Anchored Solutions AB. Cochlear,
SmartSound, Hear now. And always and the elliptical logo are either trademarks or registered trademarks of Cochlear Limited. Dolby and the dolby-D symbol are trademarks of Dolby Lab. © Cochlear Bone
Anchored Solutions AB 2015. All rights reserved. MAR15.
630652
D
You can tell the pairing mode has
been activated when the channel
indicator is flashing. Pairing mode
will be active for 20 seconds.
E
While the channel indicator light
is flashing, turn on your sound
processor.
Note: Successful pairing will be indicated
by an audible melody played in your sound
processor(s).
You are now ready to use the
TV Streamer!
processor(s). If necessary, this must be done separately for each
processor in order to hear streamed audio in both ears.
To stop listening to streaming audio:
Briefly press and release the button on your sound processor.
Visit www.cochlear.com to learn about our
full range of apps and wireless accessories.
Pairing several TV Streamers
to one sound processor
It is possible to pair up to three TV
Streamer units with your sound
processor(s).
To pair a second or third TV Streamer,
A B
follow steps and left of this
column.
C
Then press the pairing button of the
second TV Streamer two or three
times.
D
The yellow light indicator on the
front of the TV Streamer will now
blink two or three times every 2
seconds to indicate it is ready to
be paired in Channel 2 or 3 of the
sound processor.
E
Complete the pairing process by
turning on the sound processor(s).