Advertisement
Click the Network Tab to configure the TCP/IP network setting
Step2.
Figure 5-7 TCP/IP Network setting
MAC Address This is also called Ethernet address and needs no further configuration.
Link Speed This function will show the current linking speed to be either 10Mbps or 100Mbps. However,
the utility will auto-detect the current transmission speed on the network segment and set
the transmission speed for the device accordingly without your further efforts.
Duplex Mode The utility will detect the current transmission mode (half-duplex or full-duplex) on the
network segment, and set the transmission mode for the device accordingly without your
further efforts.
IP Address, Subnet Mask, Default Gateway
The IP address identifies your ADAM-6000 and ADAM-5000/TCP devices on the global network. Each
ADAM-6000 and ADAM-5000/TCP has same default IP address 10.0.0.1. Therefore, please do not initial
many ADAM-6000 and ADAM-5000/TCP at the same time to avoid the Ethernet collision.
If you want to configure the ADAM-6000 and ADAM-5000/TCP in the host PC's dominating network,
only the IP address and Subnet Mask will need to set (The host PC and ADAM Ethernet I/O must belong
to same subnet Mask).
If you want to configure the ADAM-6000 and ADAM-5000/TCP via Internet or other network domination,
you have to ask your network administrator to obtain a specific IP and Gateway addresses, then
configure each ADAM-6000 and ADAM-5000/TCP with the individual setting.
Advertisement
