Figure 3-1, Set>Actv Diagram - Garmin G1000 NXi Supplemental Maintenance Manual

•
ACTV>SET (read 'Active to Set') softkey: Causes the LRUs current settings to be copied
to the master configuration module as SET items.
The ACTV>SET softkey must be used with caution!
configured unit is installed, this softkey causes the wrong configuration to
replace the correct aircraft configuration.
In the first example shown in Figure 3-1 the SET columns do not match the ACTIVE
columns. The inequality between SET and ACTIVE indicates a configuration mismatch.
By pressing the SET>ACTV softkey, this copies the SET column to the LRU unit's
configuration memory. The settings then become the ACTIVE settings for the LRU being
configured.
When troubleshooting the system, technicians can look for inequalities between SET and
ACTIVE columns. Certain problems can be resolved simply by pressing the SET>ACTV
softkey, which reloads settings to the specific LRU from the PFD. (Note that this can also be
accomplished by reloading the configuration files for the LRU. Section 7 describes this process
for each LRU).
G1000 Supplemental Maintenance Manual
Textron Nav III Series
190-02128-04
CAUTION:
Figure 3-1, SET>ACTV Diagram
If an improperly
Page 3-2
Revision 3