Section 7 7-1– - Garmin G1000 NXi Supplemental Maintenance Manual

Hide thumbs Also See for G1000 NXi:
Table of Contents

Advertisement

Intruder Start Distance: 10 nm
Intruder Start Altitude : 600 ft above field altitude
Vertical Speed: 0 fpm
Velocity:600 kts
4. Initiate the intruder scenario and observe the following:
Traffic should be acquired at approximately 10 NM at 90 degree bearing and co-
altitude. Observe intruder closes on own aircraft at a rate of 0.1 NM/sec. Verify
that only a single target is displayed in the expected quadrant.
The intruder should transition from Other Traffic (displayed as an open diamond
with +06 displayed above), to proximate traffic (displayed as a filled white
diamond with +06 displayed above), to a Traffic Advisory (TA) alarm (yellow filled
circle with +06 displayed above.)
The aural TA annunciations are muted if the height above terrain is below
400 feet.
Note: When an IFR6000 ramp tester is used with a GTS 800, the IFR6000
must be configured for a distance that is 4 times the actual distance. For
example, if the ramp tester is located 10 ft away from an aircraft, the
IFR6000 should be configured as if it were 40 ft away from the aircraft. This
will adjust the MTL setting of the IFR6000 such that it will see the GTS 800
low power interrogations and reply to the interrogations
G1000 Supplemental Maintenance Manual
Textron Nav III Series
190-02128-04
NOTE
This area intentionally blank.
Page 7-49
Revision 3

Advertisement

Table of Contents
loading

Table of Contents