Figure 3-9 - Airframe Change Confirmation - Garmin G1000 NXi Supplemental Maintenance Manual

5. Once the appropriate airframe option is selected, the cursor moves to the ITEM window.
Rotate the small FMS knob to activate the drop-down menu. Highlight "Cessna XXX –
Baseline Configuration" (where XXX is the airframe type selected above) and press
the ENT key to select it. The PRODUCT field will then populate.
The PRODUCT window displays information regarding each G1000 LRU. The
LRU column depicts the reported software version of the LRU (may be blank if
PFD cannot communicate with the unit yet until after config files are loaded).
The CARD VERS column shows the LRU software version stored on the Loader
Card.
The SOFTWARE column may or may not have all boxes checked automatically.
For the initial software load in the system all software boxes should be checked
to load all files. This is done by pressing the CHK ALL softkey when instructed
below.
The CONFIGURATION column defaults to having all unit configuration boxes
checked.
The hardware serial number is used to determine appropriate software for the
GIA COM, GIA NAV, GMU 44, and GSA 8X units. Until the system
configuration loads sufficiently to access and read these units, they may show a
"INV" invalid status under the LRU VERS and CARD VERS columns with up to
two line items per item (representing different hardware configurations). After
the configuration files are loaded, the units will update and remove the "INV"
status and will load automatically.
6. Press the CHK All softkey.
7. Press the Load softkey.
8. Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" or White "N/A" in all Configuration and Software columns.
•
"Upload Complete.............COMPLETE" in the summary box.
9. Press the ENT key to acknowledge the prompt that appears in the pop-up box..
G1000 Supplemental Maintenance Manual
Textron Nav III Series
190-02128-04
Figure 3-9 – Airframe Change Confirmation
NOTES
Page 3-19
Revision 3