Garmin G1000 NXi Supplemental Maintenance Manual page 52

Synthetic Vision System Enablement
Follow this procedure to enable the Synthetic Vision feature.
Insert the SVS Enablement card in the top slot of the PFD and power on the PFD in
configuration mode.
If a message appears on the PFD stating an "arfrm_imgs.zip" file is not present, follow
the on screen instructions to continue. This file will be loaded in Section 3.11.
On the PFD, select the "System Upload" page using the small FMS knob.
Push in the FMS knob to activate the cursor in the Group field. Rotate the small FMS
knob to highlight "Configuration Files" and press the ENT key to select it.
In the ITEM window, rotate the small FMS knob to highlight "Enable SVS Single PFD"
and press the ENT key to select it.
Press the Load softkey.
Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration column for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
Press the ENT key to acknowledge the prompt that appears in the pop-up box.
Open the PFD circuit breakers and remove SVS enablement card.
SurfaceWatch Enablement
Follow this procedure to enable the SurfaceWatch feature.
Insert the SurfaceWatch Enablement card in the top slot of the PFD and power on the
PFD in configuration mode.
If a message appears on the PFD stating an "arfrm_imgs.zip" file is not present, follow
the on screen instructions to continue. This file will be loaded in Section 3.11.
On PFD, select the "System Upload" page using the small FMS knob.
Push in the FMS knob to activate the cursor in the Group field. Rotate the small FMS
knob to highlight "Enable_SurfaceWatch" and press the ENT key to select it.
In the ITEM window, rotate the small FMS knob to highlight "SurfaceWatch Feature
Enable" and press the ENT key to select it.
Press the Load softkey.
Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration column for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
Press the ENT key to acknowledge the prompt that appears in the pop-up box.
Open PFD circuit breaker and remove the SurfaceWatch enablement card.
G1000 Supplemental Maintenance Manual
Textron Nav III Series
190-02128-04
Page 3-32
Revision 3