Troubleshooting And Belt System Information - Sega SpongeBob SQUAREPANTS Owner's Manual

Table of Contents

Advertisement

15. TROUBLESHOOTING AND BELT SYSTEM INFORMATION

15-1 TROUBLESHOOTING
● In order to prevent electric shock and short circuit, be sure to turn power off before
performing work.
WARNING!
● Be careful not to damage the wires. Damaged wires may cause electric shock or
short circuit.
● After removing the cause of the functioning of the Circuit Protector, reinstate the
Circuit Protector. Depending on the cause of the functioning, using the Circuit
Protector as is without removing the cause can cause generation of heat and fire
hazard.
● In the event that a problem cannot be resolved by employing the procedures listed
in this manual, be sure to request service from the office shown on this manual or
the dealer from whom the product was originally purchased. Attempts to employ
procedures other than those specified in this manual can cause electrical shock,
shorting, or fire.
● In the event of a problem that is not described here, be sure to contact the office
shown on this manual or the dealer from whom the product was originally
purchased. Careless attempts at repair can result in electrical shock, shorting, or
fire.
If a problem occurs, first check to make sure that the wiring connectors are properly connected.
TABLE 15. 1
PROBLEM
When the main SW is
turned ON, the machine
is not activated.
Sound is not emitted from
the speakers or woofers.
CIRCUIT PROTECTOR
www.seuservice.com
CAUSE
The power is not ON.
Incorrect power source/voltage.
The CIRCUIT PROTECTOR
functioned due to momentary
overcurrent.
Sound volume adjustment is not correct. Adjust the Switch Unit's sound adjustment volume
CIRCUIT PROTECTOR
FIG. 15. 1
COUNTERMEASURES
Firmly insert the plug into the outlet.
Make sure that the power supply/voltage are correct.
After eliminating the cause of overload, have the
Circuit Protector of the AC Unit restored.
.
Functions due to the activation of
bimetal. To restore the function,
wait for approximately one minute
or longer until the bimetal cools off.
(Press the Button.)
22

Advertisement

Table of Contents
loading

Table of Contents