Riello RiCloud User Manual page 40

Linking the boiler RF receiver to the
WiFi Box
If installing a boiler RF receiver, please
follow the procedure below.
Press the prismatic dome clear LED
button (A) on the WiFi Box and hold
for 5 seconds until the green and red
LEDs flash slow at the same time (1
second).
Press and hold again for 5 seconds
until the green
momentarily switch off and then
flash slowly (every 2 seconds).
WiFi Box
A
Press the prismatic dome clear LED
button (B) on the boiler RF receiver
and hold for 5 seconds until the green
and red LEDs flash frequently (every
0.5 seconds) at the same time.
The WiFi Box flashes frequently (every
0.5 seconds) to show the link has
been made.
Press the button on the WiFi Box again
to confirm.
The boiler RF receiver auto-configures
to normal operating mode.
and red LEDs
Ricevitore
Boiler RF
receiver
RF caldaia
B
87
9
This may take up to 2 minutes,
after which
automatically returns to the
HOME screen.
Should the link not be successful,
please contact the Authorised Service
Centre.
Linking the boiler RF receiver to the
RiCLOUD
RiCLOUD programmable thermostat
can be linked to a wireless receiver
if you want to replicate the relay
functionality on the thermostat in a
remote zone (e.g. zone valve), which
is not accessible with a cable (wireless
access).
Follow the procedure below to link
them:
Press the prismatic dome clear LED
button on the boiler RF receiver and
hold for 5 seconds until the green
and red LEDs flash slow (1 seconds) at
the same time (once linked the flash
returns to normal).
the RiCLOUD