Paper Roll Installation - VeriFone VX675 Operating Manual

2.6 P R
A P E R O L L
Before you can process transactions that require a receipt or records, you must install paper in the
printer section of your terminal.
The VX675 uses a roll of single-ply, thermal-sensitive paper for either the 38 mm or the 49 mm
diameter version.
A pink out-of-paper indicator line appears on the edge of the paper approximately 100cm before the
end of the roll. After this line appears, there is enough paper remaining on the roll to conclude at least
one transaction.
CAUTION: Store thermal paper in a dry, dark area. Handle thermal paper carefully: impact, friction,
temperature, humidity, and oils affect the colour and storage characteristics of the paper.
Instructions:
1. Gently pull the latch (A) located on top back of the terminal to unlock the paper roll cover.
2. Lift the printer cover up and back (B) taking care not to dislodge the printer roller.
3. Remove any partial roll of paper in the printer tray.
4. If applicable, loosen the glued leading edge of the new roll of paper or remove the protective
strip. Unwind the paper roll past any glue residue.
5. Hold the roll so the paper feeds from the bottom of the roll when the terminal is inverted.
6. Drop the paper roll into the printer tray, and pull paper up past the glue residue on the paper
roll.
7. Close the paper roll cover by gently pressing directly on the cover until it clicks shut, allowing
a small amount of paper past the glue residue to extend outside the printer door.
V X 6 7 5 M E R C H A N T O P E R A T I N G G U I D E
I
N S T A L L A T I O N
8