Table of Contents
Advertisement
4.2
PB-2500J Parameter Configurer
Item
F/W Version
DC Voltage
CAP Energy
Auto-start _ seconds after DC
applied
Behavior for DC Loss (<9V)
Shutdown at Low Voltage
Shutdown at High Voltage
SuperCAP Lifetime Extension
Parameter Control
Shutdown Control
PB-2500J-PCIe/ CSM
Description
Shows the firmware version of your PB-2500J
Shows the current input voltage of your PB-2500J
Shows the current charged energy status (rated 2500Ws Max.)
The time delay (in seconds) to start PB-2500J once your computer has
been powered on.
This allows you to set the delay time (in seconds) to shutdown when DC
voltage drops below 9V.
This allows you set the low voltage limit and delay time (in seconds) to
shutdown (Note: DO NOT set voltage lower than 10V)
This allows you set the high voltage limit and delay time (in seconds) to
shutdown (Note: DO NOT set voltage higher than 32V)
This setting allows you to extend the lifespan of the Supercapacitors on
your PB-2500J. Lifespan extension settings are approximate figures and
may not exactly reflect real world applications.
Update Parameters: Click on this button for new parameters to take effect.
Get Parameters: Click on this button to acquire current parameters.
Load Default: Clicking on this button to load default parameters.
Re-train: This button will re-train PB-2500J to be customized to the
system's required shutdown time.
Reset: This button will reset (erase) previous Re-train shutdown settings.
34
Advertisement
Table of Contents
