Switches And Jumpers; Mpcie / Msata Selection For Mpcie1 (Jp1); Usb Power Selection (Jp2); Table 42: Pin Assignment Jp1 - Kontron mITX-DNV User Manual

7.16. Switches and Jumpers

The product has several jumpers which must be properly configured to ensure correct operation.

Figure 28: Jumper Connector

For a three-pin jumper (see Figure 25), the jumper setting is designated "1-2" when the jumper connects pins 1 and 2.
The jumper setting is designated "2-3" when pins 2 and 3 are connected and so on. You will see that one of the lines
surrounding a jumper pin is thick, which indicates pin No.1.
To move a jumper from one position to another, use needle-nose pliers or tweezers to pull the pin cap off the pins
and move it to the desired position.

7.16.1. mPCIe / mSATA Selection for MPCIE1 (JP1)

Figure 29: mPCIe / mSATA Selection JP1

Table 42: Pin Assignment JP1

Jumper Position
Description
Pin 1-2 Pin 2-3
X - mPCIe
- X mSATA
"X" = Jumper set (short) and "-" = jumper not set (open)

7.16.2. USB Power Selection (JP2)

Figure 30: USB Power Selection JP2

Table 43: Pin Assignment JP2

www.kontron.com
1
2
3
1
2
3
mITX-DNV - User Guide, Rev. 1.0
// 53