Ccr Commands; Summary And Examples - Tait TM8100 Protocol Manual

2.8

CCR Commands

2.8.1

Summary and Examples

Examples
TM8100/TM8200 Computer-Controlled Data Interface (CCDI) Protocol Manual
© Tait Electronics Limited April 2007
The messages in the following table are sent from the DTE to the RU.
Message
Rssxxxxxxxxxcc
Tssxxxxxxxxxcc
Hssxcc
Jssxxxcc
Assxxxxcc
Bssxxxxcc
Cssxxxxcc
Dssxxxxcc
Sssxxxxxcc
Isstplcc
Nsspxxxxxcc
Pssxcc
Qssxcc
Esscc
In all cases, if the command is received without error by the RU and all the
parameters are valid, the command will be executed and the prompt will be
returned to the DTE. If an error arises, the DTE will be notified with an
appropriate response.
f0200D8 Enter ccr from ccdi
E005B Exit - same effect as "^"
R0945320000087 Set Rx frequency to 453.2MHz
T0945320000085 Set Tx frequency to 453.2MHz
Q01PFE Pulse command, returns "P" when minimum config
exists
P0111E Set power to Very Low
P0141B Set power to High
H01324 Set bandwidth to Wide
H01126 Set bandwidth to Narrow
A0406708E Set Rx ctcss to 67Hz
A0400009B Set Rx ctcss to 0Hz
B0406708D Set Tx ctcss to 67Hz
B0400009A Set Tx ctcss to 0Hz
C03023C5 Set Rx DCS to 23
C03000CA Set Rx DCS to 0
D03023C4 Set Tx DCS to 23
D03000C9 Set Tx DCS to 0
S051234549 Dial 12345
Cmd Function
R Go to Receive Frequency
T Load Transmit Frequency
H Set Bandwidth
J Set Volume Level
A Receive CTCSS Value
B Transmit CTCSS Value
C Receive DCS Value
D Transmit DCS Value
S Encode Selcall Sequence
I Set Selcall Parameters
N Set ANI
P Transmitter Output Power
Q Query Radio Pulse
E Exit CCR Mode
CCR 61