Tait TM8100 Protocol Manual page 25

[FUNCTION] [SUBFUNCTION]
0
0
(functions)
1
2
2
3
4
5
TM8100/TM8200 Computer-Controlled Data Interface (CCDI) Protocol Manual
© Tait Electronics Limited April 2007
'f ' is sent as a single ASCII character and represents the FUNCTION
■
command.
[FUNCTION] is a single ASCII characters representing the required
■
function category.
[SUBFUNCTION] is up to two ASCII characters and is used to extend
■
the range of the [FUNCTION] parameter.
[QUALIFIER] is an ASCII character string representing the action to be
■
taken, depending on the value of [FUNCTION] and
[SUBFUNCTION].
[QUALIFIER] Action
none
0
1
0-9
0-25
0
1
0
1
2
3
0
1
2
Switch to CCR mode.
Disable CCDI volume control.
Enable CCDI volume control (refer to
SUBFUNCTION=2).
Set volume level. 0=off, 1-9=loudness.
Set volume level. 0=off, 1-25=loudness.
Disable selcall output RING messages.
Enable selcall output RING messages.
Disable PROGRESS output messages.
Enable PROGRESS output messages.
Enable KEYPRESS progress messages.
Disable KEYPRESS progress messages
(default).
Disable channel PROGRESS output
messages (default).
Enable channel PROGRESS output
messages (unsolicited).
Refer to "PROGRESS" on page
= 21 User Initiated Channel Change.
Report current channel (solicited).
Support
TM8100: Yes
TM8200: No
Yes
Yes
TM8100:
before v2.06
TM8200: No
TM8100:
from v2.06
TM8200: Yes
Yes
Yes
Yes
Yes
TM8100: No
TM8200:
from v2.05
TM8100:
from v2.03
TM8200:
from v2.05
44, [PTYPE]
CCDI 25