Tait TM8100 Protocol Manual page 45

[PTYPE] [PARA1] Function
06 none Receiver Not Busy
The receiver no longer detects an RF signal on the current channel. This message will be
sent when the current channel becomes not busy.
07 none PTT Mic Activated
The PTT has been pressed. This message will be sent whenever the PTT is pressed in an
attempt to transmit.
08 none PTT Mic Deactivated
The PTT has been released. This message will be sent whenever the PTT is released after
attempting to transmit.
16 none Selcall Retry
17 none Radio Stunned
18 none Radio Revived
19 none FFSK Data Received
Indicates to that the radio has received valid FFSK data in Command mode, and will be
sent to the PC when Transparent mode is next entered.
Note that if FFSK data is received in Transparent mode, it will be sent directly to the PC
without sending this progress message.
1C Selcall Auto-acknowledge
Indicates whether an auto-acknowledge was received from the last Selcall call.
Note that this progress message will only be generated if the radio has been
programmed to transmit Selcall Auto Acknowledge in the programming application.
0 no acknowledge received.
1 acknowledge received.
1D SDM Auto-acknowledge
Indicates whether an Auto Acknowledge was received from the last SDM call.
Note that this progress message will only be generated if the radio has been
programmed to transmit SDM Auto Acknowledge in the programming application.
0 No acknowledge received.
1 Acknowledge received.
1E SDM GPS Data Received
1 Data received.
1F Radio Restarted
Indicates when the radio has been restarted.
0 Radio will restart in Command mode.
1 Radio will restart in FFSK Transparent mode.
2 Radio will restart in THSD Transparent mode.
3 Radio will restart in P25 Transparent mode.
20 none Single In-band Tone Received
TM8100/TM8200 Computer-Controlled Data Interface (CCDI) Protocol Manual
© Tait Electronics Limited April 2007
CCDI 45