Examples
TM8100/TM8200 Computer-Controlled Data Interface (CCDI) Protocol Manual
© Tait Electronics Limited April 2007
'c' is sent as a single ASCII character and represents the CANCEL
■
command.
[CANCEL_TYPE] is a single ASCII character representing the
■
cancelling type.
[CANCEL_TYPE]
Function
0
Cancel Call
(cancel call)
In conventional mode, Cancel can do the following:
clear down a Selcall call, including retries
■
■
cancel deferred calling
■
take the radio out of emergency operation if in Emergency
Tx/Rx cycles by resetting the radio
In trunked mode, Cancel can do the following:
■
act as though the front panel 'Cancel' key has been
pressed.
1
Delete SDM data of the last received SDM (if any). Available in
(delete SDM)
conventional mode only.
Note
If no [CANCEL_TYPE] is sent, then the CANCEL command
will default to CANCEL_TYPE = 0.
c0100C
a command to cancel the existing call.
c003D
also a command to cancel the existing call.
c0110B
a command to delete the currently held SDM.
CCDI
23