Table of Contents
Advertisement
4. LOADING AND INSTALLATION
4.1
Handling Precautions
(1) Do not drop or apply strong shock to the module case.
(2) Do not remove the module printed circuit board from the case.
This will cause a breakdown.
(3) Be careful not to let foreign matters such as fillings or wire chips
get inside the module. If these do get inside, remove them.
(4) Tighten the module installation screws within the following
tightening torque range.
Module installation screws
(M4 screw)
Terminal block terminal screws
(M3.5 screw)
Module installation screws
(M4 screw)
(5) When using a DIN rail adapter, take note of the following points
when mounting the DIN rail.
(a) Applicable DIN rail type (JIS C 2812 compliant)
(b) Screw spacing when mounting the DIN rail
Screw
TH-35-7.5Fe
TH-35-7.5Al
TH-35-15Fe
When mounting the DIN rail, tighten the screws at a pitch of
200mm (7.84in.) or less.
Tightening Torque Range
17
0.78 to 1.18N•m
0.59 to 0.88N•m
0.78 to 1.18N•m
Hide quick links:
Advertisement
Table of Contents
