Required components/tools:
hex key (supplied)
●
●
1x fixed (top) grille
●
●
1x bottom (movable) grille
●
●
8x16mm pan head screws
●
●
Adjusting the kickstrip grille
1
Loosen the cap screws of the adjustment brackets from both sides of the plinth using a
hex key (A).
Adjust the kickstrip to the desired depth by moving it forward/backward (B).
2
Re-tighten the cap screws of the adjustment brackets on both sides using the hex key.
3
A
36
@2
INSTALL KICKSTRIP GRILLE
B
IMPORTANT!
For toe kick heights 4 1/2" – 5" (114 – 127mm), shorten the lower grille by cutting along the
●
●
vertical ribs.
For 2" (51mm) toe kick height, an additional lower grille can be ordered.
●
●
For toe kick heights greater than 5" (127mm), lower grille is not required.
●
●
Refer to 'Door and toe kick panel dimensions' for more information.
●
●
Attach the top and bottom grilles
4
Install the top (fixed) grille
(C) with 8x16mm pan head
screws and reinstall bottom
hinge pocket cover (D).
Install the bottom
5
(movable) grille (E) with
8x16mm pan head screws.
For toe kick heights 4 1/2" – 5"
●
●
(114 – 127mm), shorten the
bottom grille by cutting along
the vertical ribs (F).
D
C
E
Toe kick and kickstrip grille
complete installation
F