Fisher & Paykel RS1884FJ Installation Manual page 24

IMPORTANT!
Ensure the doors are in line with the cabinetry front and the appliance is centered.
● ●
All four corners of the appliance must be supported firmly onto the floor to
● ●
eliminate any movement. Installing the appliance on a soft, uneven, or not level
floor may cause twisting and poor door sealing.
Required components/tools:
Phillips screwdriver or power driver (PH2 bit) at minimum torque setting
● ●
Adjusting height of the appliance inside the cabinetry
Turn the front and rear adjustment
1
screws using a Phillips screwdriver
(or powered driver) to extend the
feet until it engages the floor.
– One turn of height adjusting
nuts is equivalent to 1/32"
(0.5mm) of height adjustment.
Clockwise turn raises the height
and counter-clockwise turn
lowers height (A).
Front foot
Continue turning the adjusting screws alternately between front and rear feet until
2
you achieve the correct alignment.
3 Once you are satisfied with the alignment, raise the height of the appliance by
alternately adjusting the front and rear feet until the top surface contacts the
alcove ceiling.
Check the alignment gauges while adjusting the screws to make sure you
● ●
maintain the alignment of the appliance.
Ensure all feet are positively engaged with the floor.
4
22
!5 SINGLE INSTALLATION
A
Front foot Rear foot
adjustment adjustment
Rear foot
IMPORTANT!
Make sure to remove the depth alignment brackets before fixing the appliance inside
● ●
the cabinetry.
Open the appliance door to remove the alignment brackets from both sides of the
● ●
appliance, and then re-tighten the screws.
Required components/tools:
Phillips screwdriver or power driver
● ●
6x 8Gx16 countersunk screws (840597)
● ●
Fixing the appliance inside the cabinetry
Fix each top bracket to the ceiling
1
surface with two 8Gx16 countersunk
screws (B).
– 18" (457mm) column = 1 bracket
– 24" (610mm) column = 2 brackets
– 30" (762mm) column = 2 brackets
Note: Make sure the appliance does not
move as you open the door when you
install the screws.
C
Fix the alcove side brackets (1x per
2
each side) to the alcove side surface
with 8Gx16 countersunk screws (C).
B
B B
C C