Fisher & Paykel RS1884FJ Installation Manual page 28

IMPORTANT!
Ensure the doors are in line with the cabinetry front and the appliance is centered.
● ●
All four corners of the appliance must be supported firmly onto the floor to eliminate any
● ●
movement. Installing the appliance on a soft, uneven, or not level floor may cause twisting
and poor door sealing.
Adjusting height of the appliance inside the cabinetry
1 Turn the front and rear adjustment
screws using a Phillips screwdriver
(or powered driver) to extend the
feet until it engages the floor.
– One turn of height adjusting
nuts is equivalent to 1/32"
(0.5mm) of height adjustment.
Clockwise turn raises the
height and counter-clockwise
turn lowers height (A).
Front foot
Continue turning the adjusting screws alternately between front and rear feet until
2
you achieve the correct alignment.
3 Once you are satisfied with the alignment, raise the height of the appliance by
alternately adjusting the front and rear feet until the top surface contacts the
alcove ceiling.
Check the alignment gauges while adjusting the screws to make sure you
● ●
maintain the alignment of the appliance.
Ensure all feet are positively engaged with the floor.
4
26
!6 DUAL INSTALLATION
A
Front foot Rear foot
adjustment adjustment
Rear foot
Required components/tools:
Phillips screwdriver or power driver
● ●
5x 8Gx16 countersunk screws (840597)
● ●
Fixing the first appliance inside the cabinetry
Fix each top bracket of first appliance to ceiling surface with two (2X) 8Gx16 countersunk
1
screws (B).
– 18" (457mm) column = 1 bracket
– 24" (610mm) column = 2 brackets
– 30" (762mm) column = 2 brackets
Note: Ensure the appliance does not move as you open the door when you install the
screws.
2 Fix the alcove side bracket to alcove side surface with one 8Gx16 countersunk screw (C).
B
C
C
alcove side bracket
Note: Image shows 18" first appliance with 1 top bracket.
B