IMPORTANT!
Ensure the screw pilot holes do not penetrate the full depth of the panel.
●
●
Do not place the handle holes in marked areas to avoid clashing with panel
●
●
attachment brackets.
Minimum panel thickness where screw hole is drilled must be 5/8" (16mm).
●
●
Attach the top and side hanging brackets to (Custom) door panel
1
Remove the M8 washer and M8 nut from the M8 screws at the top the door (B).
2
Remove the top hanging bracket from the top
of the door and set aside (A).
Unscrew the adjustment screws by 1/8"
3
(3mm) to move close to the middle of
adjustment range (C).
Mark the location of the screw holes and drill
4
pilot holes to the marked location. Refer to
the custom panel template in the 'Custom
door panel dimensions' section.
32
!9
INSTALL BRACKETS TO DOOR PANEL (CUSTOM)
A
C
1/8"
(3mm)
B
Required components/tools:
Door panel attachment kit (847678)
●
●
– 6x side panel brackets (838183)
– 6x bracket slider (838201)
– 6x panel bracket spacer (846177)
– 30x M5x12 Phillips screws (845432)
(for Custom door panel only)
Mark the centerline from the top of the Custom panel and align with the 'V' notch in the
5
bracket (D).
Align the screw holes of the bracket with the screw holes of the door panel and fix the
6
hanging bracket to the door panel with M5x12 Phillips screws (E).
– 6 screws for 18" (457mm)
– 10 screws for 24" (610mm) and 30" (762mm)
D
Align the side panel bracket assembly (bracket, slider and spacer) to the screw holes on the
7
side of the door panel and fix with M5x12 Phillips screws (F).
drill with 3/32" (2.55mm) bit
●
●
powered driver (Phillips)
●
●
M4 hex key (supplied)
●
●
E
F
F