Fisher & Paykel RS1884FJ Installation Manual page 25

Dual installation includes two appliances installed side by
side. Refer to 'Cavity dimensions' section for cabinetry
overall width for dual install. A joiner kit is required for
dual installation and is available through an authorized
Fisher & Paykel dealer. Please visit fisherpaykel.com for
more information.
Attach central spacer to cabinetry
Note: The spacer must be attached between the first
and second appliances. The attachment location of the
spacer to the alcove ceiling depends on the model of
each appliance.
Depth alignment gauge
Measure from the alcove side towards the center.
1
Note: The alcove width for each side depends on the size
of the appliance to be installed. For example,
left side alcove width (A) = 18" model
● ●
right side alcove width (B) = 30" model
● ●
Refer to 'Cavity dimensions' section for dual install options.
2 Using one depth alignment gauge, mark the location and
depth position of the central spacer on the alcove ceiling
depending on the door panel thickness (C).
Make sure to follow the marked depth of the alignment
—
●
gauge relative to the door panel (D).
Fix the central spacer to the alcove ceiling with two 8Gx16
3
countersunk screws. Tighten the screws with a screwdriver
or powered drill) (E).
!6
IMPORTANT!
We recommend to place the appliance (Freezer) with water
● ●
connection first into the cabinetry to allow you to check the
connection before placing the second appliance.
Follow the instructions carefully for the correct installation
● ●
of first and second appliances inside the cabinetry.
Central spacer
DUAL INSTALLATION
A
B
C
Required components/tools:
1x depth alignment gauge (847760)
● ●
Phillips screwdriver (powered drill)
● ●
top joiner bracket (848311)
● ●
– 2x 8Gx16 mush washer screw (840371)
– 1x central spacer (847695)
D
E
23