Installation; Electrical Connection; How To Install Your Outdoor Refrigerated Drawer - Fisher & Paykel DCS RF24-D Use And Care And Installation Manual

INSTALLATION

HOW TO INSTALL YOUR OUTDOOR REFRIGERATED DRAWER

ELECTRICAL CONNECTION:

Check serial plate for correct power supply. Use only electrical power supply as specified on your appliance
serial nameplate. Do not use an extension cord!
WARNING!
Do not splash or spray water from a hose onto the refrigerated drawer! Doing so may cause an electrical shock,
which may result in severe injury or death.
GROUNDING METHOD
This product is factory equipped with a power supply cord that has a three-pronged grounded plug. It must be
plugged into a mating grounding type receptacle in accordance with the National Electrical Code and applicable
local codes and ordinances. If the circuit does not have a grounding type receptacle, it is the responsibility and
obligation of the customer to exchange the existing receptacle in accordance with the National Electrical Code
and applicable local codes and ordinances. The third ground prong should not, under any circumstances, be cut
or removed. All UL listed refrigerated products are equipped with this type of plug.
A ground fault circuit interrupter (GFI) electrical receptacle is to be used to supply electrical power to the refrig-
erated drawer for outdoor applications. Contact an electrician if you need to install one to supply electrical
power to your outdoor refrigerated drawer.
POWER REQUIREMENTS:
24" Outdoor Refrigerated Drawer
120V 60Hz
I
1800 watt
I
3 wire outlet
I
15 amp circuit
I
AC Interface
Fig. 02
Power Supply Cord
with 3-Prong
Grounding
Plug
Note:
The plug shown is for 120V units.
5
Grounding Type
Wall Receptacle
Fig. 03