Restoring The Connection Between Bluetooth Hand-Held Scanner And Cradle; Resetting The Hand-Held Scanner; Resetting The Hand-Held Scanner To Default Settings - Bartec BCS 3608ex-NI User Manual

Handscanners
BCS 3600 series
ex
11.1

Restoring the connection between Bluetooth hand-held scanner and cradle

11.2

Resetting the hand-held scanner

11.2.1

Resetting the hand-held scanner to default settings

Subject to technical modifications
17/05/18
If the hand-held scanner is not transferring any data to the cradle, restore the connection as follows:
 All cables on the host and on the cradle are securely connected.
1. Unplug the mains cable from the cradle.
2. Unplug the connection cable from the cradle.
3. Wait 3 seconds.
4. Connect the connection cable to the cradle.
5. Connect the mains cable to the cradle.
6. Connect the hand-held scanner to the cradle.
The hand-held scanner can be reset to default settings in two ways:
Factory settings (see the ZEBRA Product Reference Guide, Annex A, Standard Default
‒
Parameters)
Customised default settings.
‒
The hand-held scanner is reset to the following default settings using the "Restore Defaults" barcode:
‒ If customised default settings have been configured: the hand-held scanner is reset to the
customised default settings
‒ If no customised default settings have been configured: the hand-held scanner is reset to factory
settings.
Scanning the "Restore Defaults" barcode.

11 Faults – causes and
remedies
65 / 72