Changing Grinding Tools; Fitting Extra Weights - HTC 270 EG Manual

HTC 270 EG
4.4.2

Changing grinding tools

1. Remove the grinding tool by giving it a few light taps with a rubber hammer so
the locking mechanism releases, see Figure 4-5, page 19. Then draw the tool
up out of the guide slot.
Figure 4-5. Removing grinding tools
2. Slide the grinding tool diagonally, from above, down into the appropriate guide
slot on the tool holder, see Figure 4-3, page 18. Then push the tool fully into
the guide slot.
3. Lock the grinding tool into the tool holder by giving it a few light taps with a
rubber hammer - see Figure 4-4, page 18.
4.5

Fitting extra weights

Warning!
Make sure that extra weights are removed before tipping the machine. The
weights can come loose and cause damage and injuries.
2.0
Usage
19