Table of Contents
Advertisement
HTC 270 EG
4
Usage
4.1
General Information
The following section describes how to change tools and how to operate the grinding
machine. This section does not deal with the technical aspects of grinding, such as
selection of grinding tools, etc. For choice of tool, go to HTC's website
www.htc-floorsystems.com
Warning!
The machine may only be used or repaired by personnel who have received the
appropriate theoretical and practical training and who have read this manual.
Warning!
Never use the machine in an environment where there is a risk of explosion or
fire. Familiarise yourself with the fire-protection instructions for the working
area and follow them.
Warning!
Secure the area around the machine. No unauthorised persons should be within
a 15-metre radius of the machine. If loose objects get under the grinding head,
these may be flung out and cause personal injury.
Warning!
Use safety equipment such as safety shoes, safety glasses, protective gloves, a
mask and hearing protection.
Warning!
Only start the machine with the grinding head lowered. The rotating disc must
be touching the floor and the right tool must be fitted.
Warning!
The machine must only be used and moved on level surfaces. There is a risk of
crush injuries if the machine starts to roll.
Warning!
The grinding head must not be loaded with any other weights in addition to the
intended extra weights. Do not under any circumstances stand on the grinding
head. Too high a loading can cause the grinding head to fail.
Tip!
Check the minimum recommended cable area before using an extension cord.
You will find the recommended cable area under Technical data, page 40.
2.0
for more information.
Usage
13
Advertisement
Table of Contents
