Table of Contents
Advertisement
Introduction
Note!
This symbol means Note! and indicates that material damage can occur if the
machine or its accessories are used incorrectly. If you see this symbol next to a
section of text, you must be particularly careful when reading through the text
and not carry out any stages of which you are unsure. This is to avoid damage
to the machine or other equipment.
Tip!
This symbol means Tip! and indicates that you can get tips and advice on ways
to make operating your machine or associated equipment easier, and to avoid
wear. If you see this symbol next to a text, you should read through the text to
make your work easier and to extend the service life of the machine.
1.4
Transportation
Always make sure that the grinder is securely anchored to its surroundings and the
grinding head is lowered against the surface.To prevent the machine from being
damaged while it is secured, make sure that a spacing block is placed as support, see
Transportation, page 29. Make sure that the securing straps or other equipment used
for anchoring during transport are tightened over non-moving parts, e.g. the grinder's
chassis.
When lifting the grinder, lifting straps must be used. These must be attached
well-secured in the lifting eyes provided, , position 2, Figure 3-1, page 9. Only use
lifting straps approved for lifting equipment.
Do not transport the grinder on sloping surfaces, e.g. loading ramps, without securing it
by the lifting eyes, , position 2, Figure 3-1, page 9for example with a winch. This is
a safety measure in case the grinder starts to roll out of control. Also make sure that
people (including operator) in the vicinity are at a safe distance in order to prevent
personal injury, in the event that the grinder starts to roll out of control.
1.5
On delivery
The following items are included in the delivery. Contact your retailer if anything is
missing.
•
Grinding machine
•
Manual disc
•
Locking key for control cabinet
•
Hammer EZ system
2
HTC 270 EG
2.0
Advertisement
Table of Contents
