Description Of Controls - Control Panel - HTC 270 EG Manual

HTC 270 EG
3.2 Description of controls – Control panel
The picture below shows the machine's control panel:
Figure 3-3. Control panel
1.
2.
3.
4.
5.
6.
7.
8.
2.0
Power - Standby indicator: Indicates that the machine's functions have been
activated. Lights up when the Power knob (7) is turned to "I".
Overload - Overload indicator: Lights up to indicate that the machine is using
too much power. If this is ignored, the power supply to the motor will be
interrupted and an error code generated.
REW - Rewind: Turn the Grinding knob (5), to "REW" to start the machine's
grinding disc.
FWD- Forward: Turn the Grinding knob (5), to "FWD" to start the machine's
grinding disc.
Grinding - "Reset" (3) and "FWD" (4) knob.
Speed - Rotation speed: Regulates the rotational speed of the machine's
grinding disc.
Power - Start/stop the machine's functions: Turn the knob to "I" to activate the
machine's functions and to prepare for start. Turn the knob to "O" to switch off
the machine's functions.
EM-Stop - Emergency stop switch: In an emergency, press the switch to cut
the power to the machine.
Machine description
11