Adjusting The Machine Before And During Grinding - HTC 270 EG Manual

Usage
2. Turn the rear section of the machine to the desired position by pressing or pulling
the handle at the same time as you hold the locking pin up, see Figure 4-10,
page 26.
Figure 4-10. Setting the grinding head position
3. Release the locking pin and make sure it locks the grinding head in the desired
position.
4.9.3

Adjusting the machine before and during grinding

To obtain a good grinding result, the machine's grinding head has to be adjusted so it is
horizontal. This is done as follows:
1. Place the machine on a floor that is level and horizontal.
2. Attach the grinding tool according to section Fitting and replacing grinding tools,
page 16.
3. Choose the position for the grinding head, right, left or straight forwards
according to section Setting the grinding head position, page 24.
26
HTC 270 EG
2.0